Writing Procedure for soil compaction Lab Report

Writing Procedure for state compaction - Lab Report showcaseThis helps in reducing void ratio. The main purpose of soil compaction is to reduce trammeltlement at a lower place working loads, increase the soil shear strength, and prevent accumulation of large water pressures that may final result in soil liquefaction during earth tremors.The following equipment will be necessary in order to progress to a proper soil compaction 5 small tin containers compact mould argentiferous mixing pan and a plastic water bottle weighing balance of up to 10kg for determine the weight of soil mass a screen straight edged steel to smoothen soil stress ends and a compaction hammer of about 5.5 lbs (Fang 262).The whole process begins by preparing the soil exemplification to be used during compaction. To begin with, a soil mass is taken and passed by a sieve so as to ensure that the right quantity and type of soil is go fored. The soil sample is passed through the sieve until 3-4 lbs of the sample is obtained. The sample soil is then wetted with the right quantity of water and missed thoroughly. formerly this has been through, the wetted soil sample is carefully put into a plastic bag and left overnight (Fang 268). This is done to ensure that water in the soil sample is thoroughly absorbed so as to obtain homogeneous water content as shown in figure 1.However, before beginning compaction, it is important to set up equipments properly. As such, the compaction mold with the vile plate is measured is weighed using the weighing balance and the measurement recorded (Fang 268). It is worth noting that the compact mold should be greased to prevent soil sample from sticking in the mold.After preparing the sample, the next procedure involves testing the compaction. The first step is to lock the mold, base and the collar plate together. The soil is added to the mold and filled until over half the mold is filled with idle soil. Then, using the compaction